LEXICON MC4 vendu

djack75012 · Inscrit le: 10 Mai 2007 Messages: 28

vd processeur lexicon mc4 V1.10
en tres bon etat comme neuf facture dispo 01/2006
acheté en france premiere main
PAS DE SORTIE XLR ET NI HDMI
carton dispo

MC-4

Audio In- and Outputs:
Audio Inputs
8 stereo (RCA) or 5 stereo and one 5.1-channel or 2 stereo and two 5.1-channel connectors

Digital Audio Inputs 4 S/PDIF coaxial (RCA) and 4 S/PDIF optical (TosLink) connectors (Coaxial and optical input connectors conform to IEC-958, S/PDIF standards)
Accepts 44.1, 48, 88.2 and 96kHz sample rates
Accepts 16-24 bits PCM audio, Dolby Digital, DTS and DTS-ES discrete data formats
Main Audio Outputs 8 unbalanced (RCA) connectors for Front L/R, Center, Subwoofer, Side L/R, and Rear L/R

Peformance (Main Zone):
Analog-to-Digital Conversion
24-bit, 96kHz, dual-bit architecture

Digital-to-Analog Conversion 24-bit, 44.1 to 192kHz, multi-bit ?? architecture
Frequency Response 10Hz to 20kHz, +0.05dB/-0.1dB,
-0.5dB at 40kHz, reference 1kHz
THD + Noise Below 0.008% at 1kHz, maximum output level
Dynamic Range 108dB minimum, 22kHz bandwidth
Signal-to-Noise Ratio 108dB minimum, 22kHz bandwidth
Input Sensitivity 200mVrms (2Vrms for maximum output level) at 0dB input gain
Input Impedance 100kO in parallel with 150pF
Output Level 150mVrms typical, 6Vrms maximum (RCA outputs); 300mVrms typical, 12Vrms maximum (XLR outputs, MC-8 Balanced only); maximum value with full-scale input signal and volume at +12dB
Output Impedance 100 in parallel with 150pF

Video Inputs and Outputs:
Video Inputs 5 composite (RCA), 5 S-video, and 3 component video (RCA)
Video Outputs 1 composite (RCA), 1 S-video, and 1 component (RCA)

Peformance (Composite & S-Video):
Formats NTSC, PAL, and SECAM
Switching Active
Output Level 1.0V peak-to-peak
Impedance 75O
Input Return Loss >40dB
Differential Gain <0.5%
Differential Phase <0.5%
Bandwidth >25MHz
K Factor <0.3%
Gain ±0.15dB
Signal-to-Noise Ratio >65dB
Frequency Response 10Hz to 10MHz + 0.1/-0.3dB

Performance (Component Video):
Formats
3-channel (Y, Pr, Pb), format-independent

Switching
Active

Impedance 75O
Bandwidth >150mHz
Insertion Loss <3dB

Other:
Trigger Outputs
1 power on/off and 1 programmable connector on detachable screw terminals (+12 VDC, 0.5 amps each)

RS-232 Serial Input/Output 2 9-pin D-sub connectors
Power Requirements 90-250 VAC, 50-60Hz, 60W (universal line input), detachable power cord
Remote Control Hand-held, backlit infrared remote control unit
Batteries: Two AA[/img]